Chapter 2
Installing the Device
RUGGEDCOM RX1400
Installation Guide
24 Configuring the Device
The serial console port implements RS-232 on a female DB9 connector. The following is the pin-out for the port:
Figure14:Serial DB9 Console Port
Pin Name
1 Reserved (Do Not Connect)
2 Output Signal
3 Input Signal
4 Reserved (Do Not Connect)
5 Ground
6 Reserved (Do Not Connect)
7 Reserved (Do Not Connect)
8 Reserved (Do Not Connect)
9 Reserved (Do Not Connect)
For information about how to connect to the device via the serial console port, refer to the RUGGEDCOM ROX II CLI
User Guide for the RUGGEDCOM RX1400.
Communication Ports
Connect any of the available Ethernet ports on the device to a management switch and access the RUGGEDCOM
ROX II console and Web interfaces via the device's IP address. The factory default IP address for the RUGGEDCOM
RX1400 is https://192.168.0.2.
For more information about available ports, refer to Chapter3, Communication Ports.
Section2.12
Configuring the Device
Once the device is installed and connected to the network, it must be configured. All configuration management
is done via the RUGGEDCOM ROX II interface. For more information about configuring the device, refer to the
RUGGEDCOM ROX II User Guide associated with the installed software release.
To Next Page
Loading...
Need help?
General
