Chapter 6
Certification
RUGGEDCOM RX1400
Installation Guide
40 CSA
Section6.1.1
CSA
This device meets the requirements of the following Canadian Standards Association (CSA) standards under
certificate 16.70029035:
• CAN/CSA-C22.2 No. 142-M1987
Process Control Equipment
• CAN/CSA-C22.2 No. 213-M1987
Non-Incendive Electrical Equipment for Use in Class I, Division 2 Hazardous Locations
• CAN/CSA-C22.2 No. 60079-0:11
Explosive Atmospheres – Part 0: Equipment – General Requirements
• CAN/CSA-C22.2 No. 60079-15:12
Electrical Apparatus for Explosive Gas Atmospheres – Part 15: Construction, Test and Marking of Type of
Protection N Electrical Apparatus
• UL 916, Edition 4.0 (2007)
Standard for Energy Management Equipment
• UL 60079-0, Edition 6.0 (2013)
Explosive Atmospheres – Part 0: Equipment – General Requirements
• UL 60079-15, Edition 4.0 (2013)
Explosive Atmospheres – Part 15: Equipment Protection by Type of Protection N
• ANSI/ISA-12.12.01-2013
Non-Incendive Electrical Equipment for Use in Class I and II, Division 2 and Class III, Division 1 and 2 Hazardous
(Classified) Locations
The device is marked with a CSA symbol that indicates compliance with both Canadian and U.S. requirements.
It is specifically approved for use in hazardous locations defined as:
• Class I, Division 2, Groups A, B, C, D
• Ex nA nC IIC T4 Gc
• Class I, Zone 2, AEx nA nC IIC T4 Gc
A copy of the CSA Certificate of Compliance is available via Siemens Industry Online Support at https://
support.industry.siemens.com/cs/ww/en/view/109744578.
Section6.1.2
CSA/Sira
This device meets the requirements of the following CSA/Sira standards and is approved for use in hazardous
locations under certificates Sira 15ATEX4323X and IECEx CSA 16.0004X:
• Directive 94/9/EC (ATEX)
ATEX – Directive of the European Parliament and the Council of 23 March 1994 on the Approximation of the
Laws of the Member States Concerning Equipment and Protective Systems Intended for Use in Potentially
Explosive Atmospheres
To Next Page
Loading...
Need help?
General
