Chapter 6
Certification
RUGGEDCOM RX1400
Installation Guide
48 ICASA
IMPORTANT!
In accordance with resolution No. 506, section IX, published by ANATEL (Agência Nacional de
Telecomunicações), the maximum combined peak power of both antenna outputs is 29 dBm.
IMPORTANT!
This equipment operates on a secondary basis. That is, it is not entitled to protection against harmful
interference, even from the same type of station, and may not cause interference to systems operating
on a primary basis.
IMPORTANTE!
Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência
prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência a sistemas operando
em caráter primário.
Section6.1.12
ICASA
This device meets the requirements of the following standards established by the Independent Communications
Authority of South Africa and is certified for use in South Africa:
• Electronic Communications Act 2005
Section6.1.13
ACMA
This device meets the requirements of the following Australian Communications and Media Authority (ACMA)
standards under certificate ABN 98 004 347 880:
• Radiocommunications (Compliance Labelling – Devices) Notice 2014 made under Section 182 of the
Radiocommunications Act 1992
• Radiocommunications Labelling (Electromagnetic Compatibility) Notice 2008 made under Section 182 of the
Radiocommunications Act 1992
• Radiocommunications (Compliance Labelling – Electromagnetic Radiation) Notice 2003 made under Section
182 of the Radiocommunications Act 1992
• Telecommunications Labelling (Customer Equipment and Customer Cabling) Notice 2001 made under Section
407 of the Telecommunication Act 1997
The device is marked with an RCM symbol to indicate compliance when sold in the Australian region.
A copy of the Declaration of Conformity is available via Siemens Industry Online Support at https://
support.industry.siemens.com/cs/ww/en/view/109747499.
To Next Page
Loading...
Need help?
General
