Basic instructions
7.8 Program control operations
S7-1200 Programmable controller
System Manual, 03/2014, A5E02486680-AG
265
(D) Number of the data block
(E) Relative address of the operand
Table 7- 110 GetErrorID instruction
Indicates that a program block execution error has occurred and reports
the ID (identifier code) of the error.
Table 7- 111 Data types for the parameters
Error identifier values for the ErrorStruct ERROR_ID member
Table 7- 112 Error_ID values
Program block execution error
Operand out of range read error
Operand out of range write error
2525 9509 Invalid area write error
Data alignment read error (incorrect bit alignment)
Data alignment write error (incorrect bit alignment)
Uninitialized pointer error
Wrong version or FC does not exist
Instruction does not exist
Wrong version or FB does not exist
Instruction does not exist
Program nesting depth error
Local data allocation error
Physical input point does not exist
Physical output point does not exist
To Next Page
Loading...
