Siemens S7-1200 - Installing the TS Adapter Unit on a DIN Rail; Installing the TS Adapter on a Panel

Installation
3.3 Installation and removal procedures
S7-1200 Programmable controller
System Manual, 03/2014, A5E02486680-AG
69
3.3.8.3
Installing the TS adapter unit on a DIN rail
Prerequisites: You must have connected the TS Adapter and a TS module together, and the
DIN rail must have been installed.
Note
If you install the TS unit vertically or in high
-vibration environment, the TS module can
become disconnected from the TS
Adapter. Use an end bracket 8WA1 808 on the
DIN rail to
ensure that the modules remain connected.
Table 3- 16 Installing and removing the TS Adapter
Task
Procedure
Installation:
1. Hook the TS Adapter with attached TS module
① on the DIN rail ②.
2. Rotate the unit back until it engages.
3. Push in the DIN rail clip on each module to attach each module to the
rail.
Removal:
1. Remove the analog cable and Ethernet cable from the underside of
the TS Adapter.
2. Remove power from the TS Adapter.
3. Use a screwdriver to disengage the rail clips on both modules.
4. Rotate the unit upwards to remove the unit from the DIN rail.
WARNING
Safety requirements for installing or removing the TS Adapter.
Before you remove power from the unit, disconnect the grounding of the TS Adapter by
removing the analog cable and Ethernet cable. Failure to observe this precaution could
result in death, severe personal injury and/or property damage due to unexpected
equipment operation.
Always follow these requirements when installing or removing the TS Adapter.
3.3.8.4
Installing the TS adapter on a panel
Prerequisites: You must have connected the TS Adapter and TS module.
1. Move the attachment slider
① to the backside of the TS Adapter and TS module in the
direction of the arrow until it engages.
2. Screw the TS Adapter and TS module to the position marked with
② to the designated
assembly wall.