EasyManua.ls Logo

Siemens SENTRON PAC3200T - Web Server; Protection against Manipulation; Introduction

Siemens SENTRON PAC3200T
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation
5.3 Protection against manipulation
Equipment Manual, 09/2022, L1V30415168B-03
49
5.2.3 Web server
The device can be read out with a PC/notebook via a website using the web server integrated
in the device. Communication takes place via HTTP.
The web server provides the following functions:
Device information such as serial number, firmware status etc.
Measured value view
Energy values can be downloaded as CSV file.
Start web server:
1. Connect the device to the PC or network via the Ethernet interface.
2. Make sure that the PAC2200 and the configuration computer are in the same subnet.
3. Enter the IP address of the device in the browser.
HTTP port: 80 (default setting)
Note
The web server can be deactivated with the HTTP Port: 0 setting.
5.3 Protection against manipulation
5.3.1 Introduction
The PAC3200T is equipped with a range of mechanisms to protect against deliberate and
inadvertent device manipulation.
Password protection
Hardware write protection
IP filter
Configurable Modbus TCP port
Configurable HTTP port
Housing seal and sealing

Table of Contents

Related product manuals