Siemens SIMATIC ET 200M

Interrupt, error and system messages
9.1 PROFIBUS DP
ET 200M
Operating Instructions, 12/2008, EWA-4NEB780600602-08
199
9.1.3.7 Module status
Definition
The module status reflects the status of the configured modules and represents a detailed
ID-specific diagnosis with respect to the configuration. The module status starts with the
diagnostics and consists of a maximum of 7 bytes.
The module status is then only included in the diagnostic frame if you have enabled
"enhanced diagnosis" in the configuration.
Module status
The module status for the ET 200M is structured as follows:





 
 



+

+


%\WH
%\WH
%\WH
%\WH
%\WH
%\WH
%\WH
/HQJWKRIWKHPRGXOHVWDWXVLQFOXGLQJE\WH E\WHV
&RGHIRUGHYLFHUHODWHGGLDJQRVWLFV
6WDWXVW\SH0RGXOHVWDWXV

+
0RGXOHVWDWXV
&RGHIRUVWDWXVPHVVDJH
$OZD\V
$OZD\V
0RGXOHRQVORW
0RGXOHRQVORW
0RGXOHRQVORW
0RGXOHRQVORW
0RGXOHRQVORW
0RGXOHRQVORW
0RGXOHRQVORW
0RGXOHRQVORW

%
QRPRGXOHLQYDOLGGDWD

%
LQFRUUHFWPRGXOHLQYDOLGGDWD

%
0RGXOHIDXOWLQYDOLGGDWDPRGXOH
GHIHFWLYH

%
0RGXOHRNYDOLGGDWD
Figure 9-5 Configuration of the module status for the ET 200M