ET 200M
Operating Instructions, 12/2008, EWA-4NEB780600602-08
71
Connecting
5
5.1 Overview
Introduction
This chapter shows you how to wire an ET 200M.
To set up an ET 200M, you must take into account the mechanical and electrical
configuration. Information can be found in the "Assignment Planning (Page 33)" chapter.
Basic Rules
In view of the many and varied applications of an ET 200M, this chapter can only describe a
few basic rules on its electrical configuration. You must observe at least these basic rules if
you want your ET 200M to operate faultlessly and satisfactorily.
5.2 Connecting PROFIBUS DP
5.2.1 Connecting the Bus Connector
Applicable bus connectors
To connect with the PROFIBUS DP it is preferable to use the following FastConnect bus
connectors:
● up to 12 MBaud, with vertical cable departure
– without PD jack (6ES7972-0BA50-0XA0)
– with PD jack (6ES7972-0BB50-0XA0)
● up to 12 MBaud, with diagonal cable departure
– without PD jack (6ES7972-0BA60-0XA0)
– with PD jack (6ES7972-0BB60-0XA0)
These guarantee a fast and secure wiring with FC bus lines.
Of course you can also continue to use the conventional bus connector with screw clamp
connection:
To Next Page
Loading...
