Preface
ET 200M
Operating Instructions, 12/2008, EWA-4NEB780600602-08
5
Position in the Information Landscape
The following table provides an overview of the manuals for the ET 200M
Manual Contents
"ET 200M distributed I/O device
(http://support.automation.siemens.com/WW
/view/en/1142798) "
• Configuring the mechanical and electrical
configuration
• Installing and wiring
• Commissioning and Diagnostics
• Interface module IM 153
• Order Numbers for the ET 200M
"S7-300 automation system, module
specifications
(http://support.automation.siemens.com/WW
/view/en/8859629) "
• General technical specifications
• Power supply modules
• Digital modules
• Analog modules
• Order numbers for S7-300
"ET 200M signal modules for process
automation
(http://support.automation.siemens.com/WW
/view/en/7215812) "
• Overview of the use in process automation
• Parameter assignment with
SIMATIC PDM
• Digital input group
• Digital output module
In addition to these operating instructions you will require the manual for the DP master that
is being used and the "ET 200 distributed I/O system" manual.
Manual Contents
ET 200 distributed I/O system
• System overview of the ET 200 and PROFIBUS
• Planning and commissioning
• Description of the RS 485 repeater
• Description of the S5-95U
Manual for the DP master
• Configuring and commissioning a DP master
system
• Description of the DP master
In the appendix "Order Numbers for the ET 200M (Page 247)" you will find a listing of
additional sources of information on the SIMATIC S7 and the ET 200 distributed I/O system.
The description of the parameter assignment and configuration message frame is not a
constituent part of these operating instructions. You will find a description of this on the
Internet (http://support.automation.siemens.com/WW/view/en/1455647
).
To Next Page
