● Measurement type can be selected for each channel group:
– Voltage
– Resistance (in non-redundant use)
– Temperature
● Any measuring range selection for each channel group
● Configurable diagnostics
● Configurable diagnostic interrupt
● Electrically isolated from the CPU
● Common mode < 60 V between the channels
● Configuration in Run (CiR) supported
Resolution
The resolution of the measured value is directly dependent on the integration time selected, i.e.
the longer the integration time for an analog input channel is, the more accurate the resolution
of the measured value will be.
ET 200PA SMART I/O modules
10.4 Analog input modules
ET 200PA SMART
Operating Instructions, 06/2019, A5E34192013-AB 187
To Next Page
Loading...
