Siemens SIMATIC ET 200SP - Minimum and Maximum Values; Min;Max Value Tracking

Technical specifications
7.1 Specifications
ET 200SP F-TM Count 1x1Vpp sin/cos HF (6ES7136-6CB00-0CA0)
Equipment Manual, V1.0, 01/2021, A5E47073911-AA
83
6ES7136-6CB00-0CA0
Integrated Functions
Number of counters
1
Counting frequency (counter) max.
800 kHz; with quadruple evaluation
Safety monitoring functions
Safe Operating Stop (SOS)
Yes
Safely-Limited Speed (SLS)
Yes
Safe Direction (SDI)
Yes
Safe Speed Monitor (SSM)
Yes
Counting functions
Continuous counting
Yes
Counter response parameterizable
Yes
Software gate
Yes
Counting range, parameterizable
Yes
Measuring functions
Measuring range
Frequency measurement, min.
Hz
Frequency measurement, max.
800 kHz
Cycle duration measurement, min.
1 μs
Cycle duration measurement, max.
25 s
Velocity measurement, min.
0; (user defined units)
Velocity measurement, max.
2147483; +/- (user defined units)
Accuracy
Frequency measurement
Up to 100 ppm; depending on measuring interval
and signal evaluation. At low frequency external
noise may have an effect on accuracy (reference
the graph in 2.2.3)
Cycle duration measurement
Up to 100 ppm; depending on measuring interval
and signal evaluation. At low frequency external
noise may have an effect on accuracy (reference
the graph in 2.2.3)
Velocity measurement
Up to 100 ppm; depending on measuring interval
and signal evaluation. At low frequency external
noise may have an effect on accuracy (reference
the graph in 2.2.3)
Potential separation
Potential separation channels
between the channels
No; Only one channel is available
between the channels and backplane bus
Yes
Between the channels and load voltage L+
No
between the channels and the power supply of
the electronics
No
Isolation
Isolation tested with
707 V DC (type test)
Degree and class of protection
IP degree of protection
IP20
Standards, approvals, certificates
Suitable for safety functions
Yes