Commissioning the device
4.3 Parameterizing the Comfort Panel
Comfort Panels
Operating Instructions, 08/2018, A5E36770603-AC
149
4. Press the "Continue" button. If the "Start backup" check box was selected, the device
then creates a corresponding data backup.
The data of the system memory card is then transferred to the HMI device.
After the data transfer, the state of the HMI device is the same as that of the HMI device
used to generate the automatic backup.
Accessories (Page 22)
Saving to external storage medium – backup (Page 134)
Changing the memory cards (Page 65)
Editing IP addresses and communication connections
Overview
This section describes how you can, from your HMI device, change the IP addresses of
controllers and other HMI devices in the subnet of your HMI device and adapt the associated
communication connections accordingly. This gives you the ability to create a project,
transfer it to multiple HMI devices and then adapt the respective controller connections
without changing the project.
If you change the IP addresses of other devices in the subnet of your HMI device, the
following steps are required:
● Update IP address and device name; see section
"Assigning IP address and device name (Page 150)"
● Update communication connection; see section
"Configuring a communication connection (Page 153)".
The following functions are also available:
● A scan function to list the HMI devices and PLC in the subnet.
● Filter function for the scan results
● Check assignment of IP addresses and device names for HMI devices and PLCs.
● Project IP addresses and device names for HMI devices and PLCs can be restored.
To Next Page
Loading...
