Siemens SIMATIC HMI - Mechanical Ambient Conditions; Storage Conditions; Operating Conditions

Technical information
8.5 Climatic ambient conditions
Comfort Panels
190 Operating Instructions, 08/2018, A5E36770603-AC
8.4.2
Operating conditions
The following information applies to a device installed according to the specifications in these
operating instructions.
The device was tested based on IEC 60721-3-3 Class 3M3 with the following amendments
and limitations:
Type of condition
Permitted range
Vibration according to IEC 60068-2-6 5 ... 8.4 Hz, deflection 3.5 mm
8.4 ... 150 Hz, acceleration 1 g
Shock according to IEC 60068-2-27
150 m/s
2
, 11 ms, 3 shocks
Shock pulses within the specified range can be transferred to the display but do not impact
the functionality of the device.
8.5
Climatic ambient conditions
8.5.1
Long-term storage
The following information applies to a device that is stored in its original packaging for longer
than two weeks.
The device meets the requirements according to IEC 60721-3-1 Class 1K21.
8.5.2
Transport and short-term storage
The following information applies to a device that is transported in the original packaging and
weather-proof packaging, and stored from some time.
The device was tested according to IEC 60721-3-2 Class 2K11 with the following additions
and restrictions:
Type of condition
Permitted range
Temperature
–20 ... 60 °C
Atmospheric pressure
1140 ... 660 hPa, corresponds to an elevation of -1000 to 3500 m
Relative humidity
10 ... 90 %
Pollutant concentration
SO
2
: < 0.5 ppm; relative humidity < 60% no condensation
H
2
S: < 0.1 ppm; relative humidity < 60 %, no condensation
Note
If dewing has developed, wait until the HMI device has dried completely before switching it
on.
Do not expose the HMI device to direct radiation from a heater.