Commissioning the device
4.3 Parameterizing the Comfort Panel
Comfort Panels
146 Operating Instructions, 08/2018, A5E36770603-AC
Requirement
● The Control Panel is open.
Enabling and disabling automatic backup
1. Open the "Service & Commissioning" dialog using the "Service & Commissioning" button.
2. Change to the "Automatic Backup" tab.
If the "Automatic Backup" function was enabled ("Enabled: Yes"), the "Disable & Reboot"
button is displayed.
You can see whether or not a system memory card is inserted under "Attached:".
– "Attached: Yes" means that a system memory card is in the corresponding slot of the
HMI device. The "Safely remove" button is also displayed. Always use the "Safely
remove" function to remove the system memory card from the HMI device.
– "Attached: No" means that no system memory card is in the corresponding slot of the
HMI device or that the system memory card was not recognized.
If the "Automatic Backup" function is currently disabled ("Enabled: No"), the "Enable &
Reboot" button is displayed.
3. Press the "Disable & Reboot" or "Enable &Reboot" button to disable or enable the
automatic backup.
The "System card" dialog is displayed.
To Next Page
Loading...
