Siemens SIMATIC NET SCALANCE W780 Series User Manual

Configuring with Web Based Management
6.4 "Information" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
120 Configuration Manual, 08/2018, C79000-G8976-C267-13
Content area (4)
The content area shows a graphic of the device. The graphic always shows the device
whose WBM you have called up.
The following is displayed below the picture of the device:
●
PROFINET Name of Station
Shows the PROFINET device name.
●
Diagnostics Mode
Shows whether EtherNet/IP or PROFINET is enabled.
●
System Name
Shows the name of the device.
●
Device Type
Shows the type designation of the device.
●
PROFINET AR Status
Shows the PROFINET application relation status.
– Online
There is a connection to a PROFINET controller. The PROFINET controller has
downloaded its configuration data to the device. The device can send status data to
the PROFINET controller.
In this status, the parameters set by the PROFINET controller cannot be configured on
the device.
– Offline
There is no connection to a PROFINET controller.
●
Power Line 1 / Power Line 2 / Power over Ethernet
Status of the power supplies 1 and 2 or power over Ethernet. The power line 2 and Power
over Ethernet are only displayed if they are supported by the hardware. You will find
further information on this in the operating instructions.
●
PLUG Configuration
Shows the status of the configuration data on the PLUG, refer to the section "System >
PLUG > Configuration".
●
Fault Status
Shows the fault status of the device.
●
Remote Capture
Shows whether or not the function is enabled.

Siemens SIMATIC NET SCALANCE W780 Series Specifications

General

Brand	Siemens
Model	SIMATIC NET SCALANCE W780 Series
Category	Wireless Access Point
Language	English