Configuring with Web Based Management
6.5 "System" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
226 Configuration Manual, 08/2018, C79000-G8976-C267-13
The page contains the following boxes:
●
Select the SNMP protocol from the drop-down list. The following settings are possible:
– "-" (disabled)
SNMP is disabled.
– SNMPv1/v2c/v3
SNMPv1/v2c/v3 is supported.
Note
Note that SNMP in versions 1 and 2c does not have any security mechanisms.
– SNMPv3
Only SNMPv3 is supported.
●
If you enable this option, SNMPv1/v2c can only read the SNMP variables.
Note
Community String
For security reasons, do not use the standard values "public" or "private". Change the
community strings following the initial installation.
The recommended minimum length for community strings is 6 characters.
ecurity reasons, only limited access to objects of the SNMPCommunityMIB is
possible with the SNMPv1/v2c Read Community String. With the SNMPv1/v2c
Read/Write Community String, you have full access to the SNMPCommunityMIB.
●
SNMPv1/v2c Read Community String
Enter the community string for read access of the SNMP protocol.
●
SNMPv1/v2c Read/Write Community String
Enter the community string for read and write access of the SNMP protocol.
●
Enable or disable the sending of SNMPv1 traps (alarm frames). On the "Trap" tab,
specify the IP addresses of the devices to which SNMPv1 traps will be sent.
●
SNMPv1/v2c Trap Community String
Enter the community string for sending SNMPv1/v2c messages.
To Next Page
Loading...
Need help?
General
