Configuring with Web Based Management
6.5 "System" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
227
●
– Enabled
If the function is enabled, an SNMP engine ID is generated that can be migrated. You
can transfer configured SNMPv3 users to a different device.
If you enable this function and load the configuration of the device on another device,
configured SNMPv3 users are retained.
– Disabled
If the function is disabled, a device-specific SNMP engine ID is generated. To
generate the ID, the agent MAC address of the device is used. You cannot transfer
this SNMP user configuration to other devices.
If you load the configuration of the device on another device, all configured SNMPv3
users are deleted.
●
Shows the SNMP engine ID.
1. Select the required option from the "SNMP" drop-down list:
– "-" (disabled)
– SNMPv1/v2c/v3
– SNMPv3
2. Enable the "SNMPv1/v2c Read Only" check box if you only want read access to SNMP
variables with SNMPv1/v2c.
3. Enter the required character string in the "SNMPv1/v2c Read Community String" input
box.
4. Enter the required character string in the "SNMPv1/v2c Read/Write Community String"
input box.
5. If necessary, enable the SNMPv3 User Migration.
6. Click the "Set Values" button.
To Next Page
Need help?
General
