Configuring with the WBM
7.2 The WBM
SIMATIC RF650R/RF680R/RF685R
Configuration Manual, 03/2018, C79000-G8976-C386-06
45
On the left above the main window, there are four buttons for transferring/loading/storing the
displayed configuration. You can also operate these buttons directly with key combinations.
Table 7- 1 The toolbar of the WBM
Transfer configuration to reader
With this button, you can transfer the configuration data set in the WBM to the reader.
Key combination: Ctrl + L
Load configuration from reader
With this button, you can load the configuration data currently set on the reader into
the WBM.
Key combination: Ctrl + G
Save configuration as
With this button, you can save the configuration data set in the WBM on the PC.
Key combination: Ctrl + S
Load configuration from PC
With this button, you can load the configuration data stored on the PC in the WBM.
Remember that this data is only loaded in the WBM. To transfer the data to the read-
er, you also need to click the "Transfer configuration to reader" button.
Key combination: Ctrl + O
Note
Loading a configuration
Note that you cannot transfer any user profiles and passwords to other readers using the
configuration file. After loading the configuration file on a new reader, you need to enable
user management and create new user profiles and passwords.
On the right above the main window there is the status bar with the following information:
● Display of the reader status
● Date/time display of the reader
● Drop-down list for selecting the user interface language
To Next Page
Loading...
Need help?
General