EasyManuals Logo

Siemens SIMOTION CX32-2 Commissioning And Hardware Installation Manual

Siemens SIMOTION CX32-2
432 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #264 background imageLoading...
Page #264 background image
See also
Downloading a project into the target system
(Page 197).
For more information on symbolic assignment, see the
SIMOTION Runtime Basic Functions
Function Manual.
7.7.3 Testing the axis with the axis control panel
Axis control panel
The axis control panel is used exclusively for testing axes. You can use the axis control panel
for the following tasks, for example:
To test each part of the system individually before program-driven axis motions are initiated.
In the event of an error, to test whether the individual axes and drives can be traversed
from the axis control panel
To traverse the axes for optimization purposes (controller optimization)
To perform active homing
To set and remove the axis enable
To test an axis that has been created
Requirement
The following requirements must be fulfilled for testing:
The project has been downloaded to the target system.
SIMOTION SCOUT is in online mode.
Commissioning (software)
7.7 Creating and testing axes
SIMOTION D4x5-2
264 Commissioning and Hardware Installation Manual, 03/2018, A5E33441636B

Table of Contents

Other manuals for Siemens SIMOTION CX32-2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMOTION CX32-2 and is the answer not in the manual?

Siemens SIMOTION CX32-2 Specifications

General IconGeneral
BrandSiemens
ModelSIMOTION CX32-2
CategoryControl Unit
LanguageEnglish

Related product manuals