7.19 Powering down the system
If you wish to shut the system down, you must ensure that all axes and system parts are set
to a safe state. You can set this up by providing a separate motion task, for example.
Once the system is at a standstill, you can switch off the power supply.
Note
You must observe the safety notes for SINAMICS components, which you will find in the
corresponding SINAMICS manuals.
Commissioning (software)
7.19 Powering down the system
SIMOTION D4x5-2
Commissioning and Hardware Installation Manual, 03/2018, A5E33441636B 317
To Next Page
Loading...
Need help?
General
