Requirements
●
The bushing for the cooling fins (external heat sink) has been fitted in the rear wall of the
control cabinet.
● Please ensure the area around the seal is both smooth and clean (② please see figure
titled "Panel cutout").
● Seal available (for the article number, see the
SIMOTION D4x5-2
Manual, Section
Spare
parts and accessories
)
,QVWDOODWLRQFXWRXW
IRUKHDWVLQN
PD[5
&DELQ
HWUHDUSDQHO
Figure 3-4 Panel cutout
Installing
3.2 Installing the SIMOTION D4x5-2
SIMOTION D4x5-2
40 Commissioning and Hardware Installation Manual, 03/2018, A5E33441636B
To Next Page
Loading...
