Siemens SIMOVERT MASTERDRIVES MC Series

To Next Page

To Previous Page

Commissioning

4.2 Table of the settings

Connecting SIMOVERT MASTERDRIVES MC to the Technology-CPU

14 Product Information, 03/2008, A5E00272072-05

4.2 Table of the settings

Settings for commissioning

You will require this data for the following commissioning steps. As preparation, you can

define the values using this table.

DP cycle ________ ms

❑ Incremental encoder Specify Encoder

❑ Absolute encoder

❑ Reference cam + encoder zero mark

❑ Only encoder zero mark

❑ Only reference cam

❑ 1. Zero position to the right of the

reference cam

Referencing mode

❑ 1. Zero position to the left of the

reference cam

"Measuring" function ❑

Encoder type (Order No.) 1Fxxxxx- _ xxxx-x _ xx

Rated motor speed/max. speed, axis ______ 1/min

Master application cycle/position controller

clock cycle

______

Telegram type (refer to the decision table) ______

PROFIBUS address ______

Siemens SIMOVERT MASTERDRIVES MC Series - Table of the Settings