Siemens SINAMICS PERFECT HARMONY GH180 - Replacing the Compact Flash Card; Figure 10-17 Nxgpro Digital Control Rack - Compact Flash

10.7.8 Replacing the Compact Flash Card
Refer to the following 󹪝gure when replacing the Compact Flash card (applies to NXGpro Control
ONLY).


1 Compact Flash card insertion slot
Figure 10-17 NXGpro Digital Control Rack - Compact Flash
Perform the following steps to replace the Compact Flash card.
1. Remove the Compact Flash card from the compact 󹪞ash slot located on the NXGpro Digital
Control Rack (DCR).
2. Copy the stored data of the old card to the new original Siemens card.
3. Place the new card into the compact 󹪞ash slot on the DCR.
Maintenance
10.7 Remove and Replace
Type 6SR5 Air-Cooled
Operating Instructions, AK, A5E39390112 85