Figure 10-20 340 - 430 A, 4Q 325 A - proper alignment of power cell mounting with receiving holes
Note
Properly Remove and Install Power Cells
When removing and / or installing power cells, be sure to use the handle as shown as shown
in gures "... proper alignment of power cell mounting with receiving holes".
Do NOT remove or install the power cells by pulling or pushing on the fuses and bypass
contactors that are located on the front panel of power cells.
Maintenance
10.7 Remove and Replace
Type 6SR5 Air-Cooled
88 Operating Instructions, AK, A5E39390112
To Next Page
Loading...
