Siemens SINUMERIK 808D ADVANCED - Page 490

Parameter Manual
490 Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
PROG_EVENT_IGN_STOP
MD 20193, 121
PROG_EVENT_MASK
MD 20108, 102
PROG_EVENT_MASK_PROPERTIES
MD 20109, 102
PROG_NET_TIMER_MODE
MD 27850, 174
PROG_SD_POWERON_INIT_TAB
MD 10709, 40
PROG_SD_RESET_SAVE_TAB
MD 10710, 41
PROG_TEST_MASK
MD 10707, 39
Program control from the HMI (retentive area), 429
Program selection via lists, 429
R
RATED_OUTVAL
MD 32250, 221
RATED_VELO
MD 32260, 222
Reading / writing NC data
Job, 425
Result, 425
Reading and writing PLC variables, 454
REFP_CAM_DIR_IS_MINUS
MD 34010, 246
REFP_CAM_IS_ACTIVE
MD 34000, 245
REFP_CAM_MARKER_DIST
MD 34093, 252
REFP_CAM_SHIFT
MD 34092, 252
REFP_CYCLE_NR
MD 34110, 254
REFP_MAX_CAM_DIST
MD 34030, 247
REFP_MAX_MARKER_DIST
MD 34060, 249
REFP_MOVE_DIST
MD 34080, 250
REFP_MOVE_DIST_CORR
MD 34090, 251
REFP_NC_START_LOCK
MD 20700, 141
REFP_PERMITTED_IN_FOLLOWUP
MD 34104, 253
REFP_SEARCH_MARKER_REVERSE
MD 34050, 249