Siemens SINUMERIK 808D ADVANCED - Page 493

Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
493
SPIND_OSCILL_TIME_CW
MD 35440, 276
SPIND_POSCTRL_VELO
MD 35300, 273
SPIND_POSIT_DELAY_TIME
MD 35310, 274
SPIND_POSITIONING_DIR
MD 35350, 274
SPIND_RIGID_TAPPING_M_NR
MD 20094, 95
SPIND_S
MD 43200, 324
SPIND_SPEED_TYPE
MD 43206, 325
SPIND_STOPPED_AT_IPO_START
MD 35510, 278
SPIND_USER_VELO_LIMIT
MD 43235, 326
SPIND_VELO_LIMIT
MD 35100, 265
SPINDEL_LOAD_BAR_COL1
MD 366, 25
SPINDEL_LOAD_BAR_MAX
MD 365, 25
SPINDEL_LOAD_DISPLE1
MD 360, 25
SPINDLE_DISP_MODE
MD 379, 27
SPINDLE_LOAD_BAR_COL2
MD 367, 25
SPINDLE_LOAD_BAR_COL3
MD 368, 26
SPINDLE_LOAD_BAR_LIM2
MD 363, 25
SPINDLE_LOAD_BAR_LIM3
MD 364, 25
SPINDLE_LOAD_DISPLE2
MD 362, 25
SPLINE_MODE
MD 20488, 136
SPOS_TO_VDI
MD 20850, 146
STANDSTILL_DELAY_TIME
MD 36040, 281
STANDSTILL_POS_TOL
MD 36030, 281
STANDSTILL_VELO_TOL
MD 36060, 282
START_AC_FIFO
MD 28262, 187
START_MODE_MASK
MD 20112, 108
Siemens Controls