Siemens SINUMERIK 808D ADVANCED - Page 492

Parameter Manual
492 Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
SINAMICS_IBN_TIMEOUT_VALUE
MD 1091, 17
Singlas from axis/spindle, 450
SINGLEBLOCK2_STOPRE
MD 42200, 311
SLASH_MASK
MD 10706, 39
SMOOTHING_MODE
MD 20480, 133
SOFT_ACCEL_FACTOR
MD 32433, 227
SOFTKEY_CENTRE_ADJ
MD 1106, 19
Special bit memory SM bit definition (read-only), 422
SPF_END_TO_VDI
MD 20800, 145
SPIND_ACTIVE_AFTER_RESET
MD 35040, 263
SPIND_ASSIGN_TO_MACHAX
MD 35000, 257
SPIND_CONSTCUT_S
MD 43202, 324
SPIND_DEF_MASTER_SPIND
MD 20090, 95
SPIND_DEFAULT_ACT_MASK
MD 35030, 260
SPIND_DEFAULT_MODE
MD 35020, 259
SPIND_DES_VELO_TOL
MD 35150, 270
SPIND_EXTERN_VELO_LIMIT
MD 35160, 270
SPIND_FUNC_RESET_MODE
MD 35032, 260
SPIND_FUNCTION_MASK
MD 35035, 261
SPIND_MAX_VELO_G26
MD 43220, 326
SPIND_MAX_VELO_LIMS
MD 43230, 326
SPIND_MIN_VELO_G25
MD 43210, 325
SPIND_ON_SPEED_AT_IPO_START
MD 35500, 277
SPIND_OSCILL_ACCEL
MD 35410, 275
SPIND_OSCILL_DES_VELO
MD 35400, 275
SPIND_OSCILL_START_DIR
MD 35430, 276
SPIND_OSCILL_TIME_CCW
MD 35450, 277