5
"Parameters" Operating Area 03.04
5.1 Tool data
5
Ó Siemens AG, 2004. All rights reserved
5-170 SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
· Group type 4xy (grinding tools):
400 Surface grinding wheel
401 Surface grinding wheel with monitoring
402 Surface grinding wheel without monitoring
403 Surface grinding wheel with monitoring
without tool base dimension for grinding wheel
peripheral speed GWPS
410 Facing wheel
411 Facing wheel with monitoring
412 Facing wheel without monitoring
413 Facing wheel with monitoring without tool base
dimension for grinding wheel peripheral speed GWPS
490 Dresser
Offset values required
by a surface grinding
wheel
F
Z
X
Entries in
tool parameters
STC_DP1
STC_DP3
STC_DP4
STC_DP6
403
Length 1
Length 2
Radius
Wear values
according to
requirement
Other values must
be set to zero
Effect
G19:
Length 1 in Y
Length 2 in X
Radius in X/Y
Length 1 in X
Length 2 in Z
Radius in Z/X
Length 1 in Z
Length 2 in Y
Radius in Y/Z
G17:
G18:
F - Toolholder reference point
e.g.
G18: Z/X plane
Length 1 (X)
Radius
Length 2 (Y)
To Next Page
Loading...
Need help?
General
