Siemens SINUMERIK 810D

8
"Diagnosis" Operating Area 03.04
8.3 Service dis
p
la
y
8
Ó Siemens AG, 2004. All rights reserved
8-414 SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
SGE/SGA
The available signals can be seen in the above screen.
The vertical softkey Status SI take you to the Status SI screen,
SPL opens the Safe Programmable Logic screen.
SPL
In the "Variable" selection box, you can choose:
$A_INSE(P) corresponds to simultaneous selection of
$A_INSE top row; NCK origin and
$A_INSEP bottom row; PLC origin
The following should then be selected for the remaining variables:
$A_OUTSE(P)
$A_INSI(P)
$A_OUTSI
$A_MARKERSI(P)
Under Bit you can request an 8-bit range from the selected signal.