Siemens SINUMERIK 840D sl Configuration Manual

Ti/To values:
●
"PROFIBUS Integrated_1 > Equidistance > Ti/To values of the PROFIBUS"
● "I/O device > PROFINET interface [x1] > Extended options > Isochronous mode"
Match the values and compile the project again.
5.5.12 Assigning drive addresses to the NCU machine data
Procedure
To enter configured addresses in the machine data in the TIA Portal, proceed as follows:
1. Check in the TIA Portal which addresses you have assigned to the drives (see Configuring
IO modules or drive telegrams (Page 106)).
2. Transfer the addresses to the machine data (e.g. via SINUMERIK Operate).
See Adapting I/O start addresses (Page 133).
Further information
● General information concerning this machine data is available in Chapter A4 of the
SINUMERIK 840D sl Supplementary Functions Manual: Digital and analog NCK I/Os for
SINUMERIK 840D sl.
● Specific information on the individual machine data can be found in the online help of
SINUMERIK Operate.
Configuring networks
5.5 Configuring PROFINET IO with IRT
SINUMERIK STEP 7 Toolbox V15.1
112 Configuration Manual, 12/2018, A5E46279635B AA

Siemens SINUMERIK 840D sl Specifications

General

Control Type	CNC
Number of Axes	Up to 31
Max Number of Channels	10
Interfaces	Ethernet, PROFIBUS, PROFINET, USB
Interpolation	5-axis interpolation
Operating Temperature	0°C to 45°C
Relative Humidity	Up to 95% (non-condensing)
Display	TFT color display, various sizes
Programming Languages	DIN/ISO
Safety Features	Safety Integrated
PLC	Integrated PLC S7-300
Drive Interface	SINAMICS S120
Data Storage	CF card, USB
Operating System	Windows-based