Procedure
To change the Safety Integrated mode, proceed as follows:
1. Click the NCU in the network or device view and select the "Safety Integrated" entry in the
"Properties" inspector window at "General".
Figure 10-3 Properties inspector window - Safety Integrated when using NCU V4.7
2. Click the "Change Safety Integrated mode" button.
The "Change Safety Integrated mode" dialog opens. If you select an option, the effects of
the mode change are performed here.
Figure 10-4 "Change Safety Integrated mode" dialog when using NCU V4.7
3. Select the required Safety Integrated mode and confirm the reconfiguration with "Yes".
Safety configuration
10.3 Changing the Safety Integrated mode
SINUMERIK STEP 7 Toolbox V15.1
176 Configuration Manual, 12/2018, A5E46279635B AA
To Next Page
Loading...
