Siemens SINUMERIK 840D sl Configuration Manual

Note
Handling of F-blocks for SINUMERIK archives
Because
F-blocks must always be saved together with the associated hardware configuration,
F-blocks cannot be saved in reload archives.
Further information
● General
information on series commissioning archives can be found in Section "Saving and
managing data" of the "SINUMERIK 840D sl, SINAMICS S120 Commissioning CNC:NCK,
PLC, Drive for TIA" Commissioning Manual.
● Information about the differences of the archives that were created with STEP 7 V5.x is
available at "Handling SINUMERIK archives".
Configuring the NCU
3.6 Creating SINUMERIK PLC archives
SINUMERIK STEP 7 Toolbox V15.1
Configuration Manual, 12/2018, A5E46279635B AA 45

Siemens SINUMERIK 840D sl Specifications

General

Control Type	CNC
Number of Axes	Up to 31
Max Number of Channels	10
Interfaces	Ethernet, PROFIBUS, PROFINET, USB
Interpolation	5-axis interpolation
Operating Temperature	0°C to 45°C
Relative Humidity	Up to 95% (non-condensing)
Display	TFT color display, various sizes
Programming Languages	DIN/ISO
Safety Features	Safety Integrated
PLC	Integrated PLC S7-300
Drive Interface	SINAMICS S120
Data Storage	CF card, USB
Operating System	Windows-based