Result
The blocks of the basic SINUMERIK PLC program have been copied to your project. Any
copied folder structure (Page 82) has been imported.
Figure 4-3 Program blocks folder
Now you can check the copied blocks and, if applicable, manually delete the PLC basic
program blocks that you do not require (e.g. unused axis DB, channel DB, FB or FC).
If you have unused blocks in your project, some tasks take unnecessarily long, e.g. the loading
or the creation and import of SINUMERIK archives.
Programming the PLC
4.3 Adding the PLC basic program
SINUMERIK STEP 7 Toolbox V15.1
Configuration Manual, 12/2018, A5E46279635B AA 73
To Next Page
Loading...
