3. After the startup, confirm the "Diagnosis", ">>" and "NC/PLC variables" horizontal softkeys.
4. Select the "Insert variables" softkey.
The imported symbols are displayed in the "NC/PLC variables" table and can be imported.
Further information
Detailed information on how you can load the PLC symbols to the control system are contained
in the SINUMERIK 840D sl Universal Operator Manual under the "Loading PLC symbols"
keyword.
Programming the PLC
4.10 Exporting PLC symbols for SINUMERIK Operate
SINUMERIK STEP 7 Toolbox V15.1
90 Configuration Manual, 12/2018, A5E46279635B AA
To Next Page
Loading...
