Siemens SINUMERIK 840D

4
03.04 Machine Operating Area
4.6 Automatic mode
4
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition 4-161
SKP:
Activate skip levels
Blocks that cannot be executed can be skipped (10 skip levels with
SW 6.4 and higher).
Blocks to be skipped are indicated in the part program by an oblique
"/" before the block number. The skip levels in the part program are
specified by "/0" or by "/" to "/9". You can activate/deactivate skip
levels in the following window:
Program control
Skip /
Skip /1
Skip /2
Skip /2
Skip /3
Skip /4
Skip /5
Skip /6
Skip /7
SKP: Skip blocks
active
Skip /8
Skip /9
This program control window is displayed only if more than 1 skip
level was set via machine data. Only the set skip levels are displayed.
Changes to machine data are described in Section 9.1.
Display activated skip levels If more than one skip level is active, the right column indicates
whether the PLC has transmitted the skip level selection to the NC.
This allows you to see from the top window which level
·
is selected, but not yet active,
·
selected and active,
·
deselected and active,
·
deselected and not active.