Siemens SINUMERIK 840D

6
03.04 "Program" Operating Area
6.9 Pro
g
ram simulation
6
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition 6-315
Front
view
or
Half
section
Side
view
or
Full
section
Wire
model
or
Wire
model
Face
end
Periph.
surface
ditto
ditto
ditto
ditto
ditto
Menu "Details...." standard
vertical
Tool paths
on/off
or
Tool paths
on/off
· "Top view" or "top view and front view" for
milling
· "Wire-frame model" (3D without tool data) for milling
· All views for turning
Activate/deactivate representation of the tool center point path.
Deactivation also deletes any tool paths from the current model that
have already been stored (default setting: tool paths on).
Front
view...
With 2 window views only: Select active window
Possible in the same manner with "TAB"- or "NEXT WINDOW (from
V06.02.13).
Conditionally with 2 window views:
"from front..." depending on type of view active (horizontal selection)
same meaning as "from above..." or "from left..."
Rear
view...
Conditionally with 2 window views:
"from behind..." depending on type of view active (horizontal
selection) same meaning as "from below..." or "from right..."
Fit to
size
Automatic screen resizing
relative to the window activated with
.
Also possible with "ENTER" or "INPUT" key.
Zoom...
Show window pane border in active window
(Size can be altered with "+" - and "-" keys, position can be altered
with cursor keys.)