Siemens SINUMERIK 880 GA2

05.91 4 Programming of Motion Blocks
4.2.16 Axis synchronization with change of channel G200
• After programming with G200, all axes must once be programmed with G90 if compensating
values have previously been allowed for (zero offset, tool offset ...)
It is possible to synchronize all axes of a mode group or just one single axis:
• Synchronization of all axes of a mode group
N . . G200
L
F
• Synchronization of one single axis of a mode group
N . . G200 <Axis name (s)>
L
F
It is possible to specify between 1 and 5 axes.
This method offers the advantage that there is no need to wait for the stoppage of axes that
are not to be synchronized.
Examples:
• N10 G200
L
F
In block number 10 all axes of the mode group are synchronized.
• N10 G200 X Y Z
L
F
In block number 10 only the X, Y and Z axes are synchronized.
• N10 G200 X2= Y Z3=
L
F
(with extended addresses)
In block number 10 only the X2, Y and Z3 axes are synchronized.
© Siemens AG 1991 All Rights Reserved 6ZB5 410-0HD02 4–51
SINUMERIK 880, (PG)