05.91 11 Programming of Cycles
11.11 Part program handling
11.11 Part program handling
Main group f: Part program handling
The main group f is organized as follows:
Three-digit @ code
@
0: Clear program
1: Select program
2: Open program
3: Select program for simulation
0: Read block from program, absolute
1: Read block from program, according to block number
2: Copy block N . . from program 1 to program 2
3: Write comment
0: Edit word in block
1: Insert word in block
2: Read word in block
3: Clear word in block
0: Program handling
1: Block handling
2: Word handling
Main group f
fxy
Handling of @ codes:
A further part program can be processed from within a part program using the @ code. The
data required for executing the @ code must be stored in R parameters.
Each @ code has two parameters. The first parameter represents the first input R parameter.
The number of input R parameters depends on the relevant @ code. A maximum of six input
R parameters are available. The second parameter describes the first output R parameter.
Here also, a maximum of six output R parameters are available.
© Siemens AG 1991 All Rights Reserved 6ZB5 410-0HD02 11–51
SINUMERIK 880, (PG)
To Next Page
Loading...
Need help?
General
