9 Tool Offsets 05.91
9.9 Tool offset for drill
9.9 Tool offset for drill
The number “10” must be entered under P1 (tool type).
In the case of a drill, length compensation acts in the axis perpendicular to the selected axis.
Length 1
Radius
P1 : Tool type (enter:10)
P2 : Geometry, length 1
P5 : Wear, length 1
9–14
© Siemens AG 1991 All Rights Reserved 6ZB5 410-0HD02
SINUMERIK 880, (PG)
To Next Page
Loading...
