Siemens SINUMERIK 880 GA2 - Page 240

05.91 11 Programming of Cycles
11.11 Part program handling
@f03 Select program for simulation
This @ code enables a part program for special simulation ”SIMUL MARKS” to be
selected from within a part program.
Syntax: @f03 <R
x
>
Input parameters: R
x
: Program type (%=1, L=2)
R
x
+1: Program number
CL 800 reserved word: PP SELECT SIM
@f04 Disable program for execution
This @ code enables another part program specified by the program number and
program type to be disabled from within a part program.
Syntax: @f04 <R
x
> <R
y
>
Input parameters: R
x
: Program type (%=1, L=2)
R
x
+1: Program number
Output parameters: R
y
: Error feedback
0: No errors
1: No program
5: Input error
CL 800 reserved word: Not yet defined.
@f05 Enable program for execution
This @ code enables another part program specified by the program number and
program type to be enabled for execution from within a part program.
Syntax: @f05 <R
x
> <R
y
>
Input parameters: R
x
: Program type (%=1, L=2)
R
x
+1: Program number
Output parameters: R
y
: Error feedback
0: No error
1: No program
5: Input error
CL 800 reserved word: Not yet defined.
© Siemens AG 1991 All Rights Reserved 6ZB5 410-0HD02 11–53
SINUMERIK 880, (PG)