11 Programming of Cycles 05.91
11.11 Part program handling
@f12 Copy ”X” to program ”Y”
This @ code copies a block specified by its block number from a source part program
to the end of a target part program. The target part program must have been
generated before by using @f02, i.e. @f12 is not able to create a new program.
Syntax: @f12 <R
x
> <R
y
>
Input parameters: R
x
: Program type of source program
(%=1, L=2, cycle = 3)
R
x
+1: Source program number
R
x
+2: Block number in source program
R
x
+3: Program type of target program
(%=1, L=2, cycle = 3)
R
x
+4: Target program number
R
x
+5: Block number in target program
Output parameters: R
y
: Error feedback
0: No error
1: Block not available
2: Target program in EPROM or write-
protected
3: Parity error
4: Memory full
5: Target program not available
6: Source program not available
CL 800 reserved word: COPY BLOCK
11–56
© Siemens AG 1991 All Rights Reserved 6ZB5 410-0HD02
SINUMERIK 880, (PG)
To Next Page
Loading...
Need help?
General
