[schalttafeleinbau-gehaeuse-4zeilig-display-drittel-st-040403, 1, en_GB]
Figure 3-16
Panel flush mounting of a device (housing size
1
/
3
)
[schalttafeleinbau-gehaeuse-4zeilig-display-halb-st-040403, 1, en_GB]
Figure 3-17
Panel flush mounting of a device (housing size
1
/
2
)
Rack and Cubicle Mounting
To install the device in a rack or cubicle, a pair of mounting rails; one for top, one for bottom are required. The
ordering codes are stated in Appendix, Section A Ordering Information and Accessories.
•
Screw on loosely the two angle brackets in the rack or cabinet, each with 4 screws.
•
Remove the 4 covers at the corners of the front cover. Thus, 4 elongated holes in the mounting bracket
are revealed and can be accessed.
•
Fasten the device to the mounting brackets with 4 screws.
3.1.3.2
Mounting and Commissioning
3.1 Mounting and Connections
200 SIPROTEC 4, 7VK61, Manual
C53000-G1176-C159-5, Edition 05.2018
To Next Page
Loading...
