After startup of the device featuring a 4-line display, default measured values are displayed. Use the arrow
keys on the device front to select different measured value views to be used as the so-called default display.
The start page of the default display, which will open after each startup of the device, can be selected via
parameter 640 Start image DD. The available representation types for the measured value are listed in the
Appendix.
Settings
Addresses which have an appended “A” can only be changed with DIGSI, under “Additional Settings”.
Addr. Parameter Setting Options Default Setting Comments
610 FltDisp.LED/LCD Target on PU
Target on TRIP
Target on PU Fault Display on LED / LCD
625A T MIN LED HOLD 0 .. 60 min 0 min Minimum hold time of latched
LEDs
640 Start image DD image 1
image 2
image 3
image 4
image 5
image 6
image 1 Start image Default Display
Information List
No.
Information Type of
Informa-
tion
Comments
- Test mode IntSP Test mode
- DataStop IntSP Stop data transmission
- UnlockDT IntSP Unlock data transmission via BI
- Reset LED IntSP Reset LED
- SynchClock IntSP_Ev Clock Synchronization
- >Light on SP >Back Light on
- HWTestMod IntSP Hardware Test Mode
- Error FMS1 OUT Error FMS FO 1
- Error FMS2 OUT Error FMS FO 2
- Distur.CFC OUT Disturbance CFC
1 Not configured SP No Function configured
2 Non Existent SP Function Not Available
3 >Time Synch SP >Synchronize Internal Real Time Clock
5 >Reset LED SP >Reset LED
11 >Annunc. 1 SP >User defined annunciation 1
12 >Annunc. 2 SP >User defined annunciation 2
13 >Annunc. 3 SP >User defined annunciation 3
14 >Annunc. 4 SP >User defined annunciation 4
15 >Test mode SP >Test mode
16 >DataStop SP >Stop data transmission
51 Device OK OUT Device is Operational and Protecting
52 ProtActive IntSP At Least 1 Protection Funct. is Active
55 Reset Device OUT Reset Device
56 Initial Start OUT Initial Start of Device
67 Resume OUT Resume
2.1.2.3
2.1.2.4
Functions
2.1 General
30 SIPROTEC 4, 7VK61, Manual
C53000-G1176-C159-5, Edition 05.2018
To Next Page
Loading...
