Default Display
4-line Display
The following selection is available as start page which may be configured. Parameter 640 Start image DD
allows to select which of the available default displays will be displayed in normal mode.
[vk61-alle-grundbilder-261102-kn, 1, en_GB]
Figure D-1
Default displays
Spontaneous Fault Indication of the 4-Line Display
The spontaneous annunciations on devices with 4-line display serve to display the most important data about
a fault. They appear automatically in the display after pick-up of the device, in the sequence shown below.
Relay PICKUP:
A message indicating the protective function that
picked up first
PU Time Elapsed time from pick-up until drop-off
TRIP Time Elapsed time from pick-up until the first trip command
of a protection function
D.5
Default Settings and Protocol-dependent Functions
D.5 Default Display
282 SIPROTEC 4, 7VK61, Manual
C53000-G1176-C159-5, Edition 05.2018
To Next Page
Loading...
