Siemens siprotec 7SA6 User Manual

Functions
6-4
7SA6 Manual
C53000-G1176-C156-2
Exiting the
Setting Mode
If an attempt is made to exit setting modification mode using the key or the key,
the message Are you sure? will be displayed followed by the responses Yes, No,
and Escape (see Figure 6-4). If the response Yes is selected, modification of settings
can be confirmed by pressing the key. To cancel pending modifications to settings
and exit setting modification mode, the response No must be selected. Press the
key until the response No is highlighted. Press the key to confirm and exit. Incor-
rect entries may be retracted in this manner. To remain in the setting modification
mode, press the key until the response Escape is highlighted. Press the key
to confirm, and the user can remain in setting modification mode without down-loading
modifications.
Figure 6-4 Ending the setting mode using the front control panel
From PC
with
DIGSI
®
4
To select a function, double-click on Settings, and then double-click on the desired
setting function (e.g., Power System Data 1 is selected by double-clicking Set-
tings, and then double-clicking Power System Data 1 as illustrated in Figure 6-5).
K450.gif
Figure 6-5 Navigating using DIGSI
®
4 — example
A dialogue box associated with the selected function is displayed (e.g., if Power Sys-
tem Data 1 function is selected, the dialogue box shown in Figure 6-6 will appear).
If a function contains many settings, the dialogue box may include multiple windows.
In this situation, the user can select individual windows via tabs located at the top of
MENU
ENTER
ENTER
ENTER
ENTER
Are you sure?
>Yes No Escape
ENTERENTER
Settings are ok
>Continue
:

Siemens siprotec 7SA6 Specifications

General

Brand	Siemens
Model	siprotec 7SA6
Category	Relays
Language	English