Control During Operation
7-40 7SA6 Manual
C53000-G1176-C156-2
Figure 7-41 Function selection window in DIGSI® 4 - Example
In the Control subdirectory you can click on the Taggings under Function Selection in
the right window.
Doubleclick Taggings. A dialogue box “
Tagging” is opened. (Figure 7-42).
Figure 7-42 Tagging dialogue box
In the "Designation" column the different modes have been listed, "Actual" refers to
the current state with "OFF" meaning that the mode is not effective, "ON" meaning that
it is effective.
By clicking one of buttons under "Setpoint" you can change the desired mode. In a se-
curity query you will be requested to confirm this.
To Next Page
Loading...
