Index
Index-2 7SA6 Manual
C53000-G1176-C156
Configuration 5-1
Operator interface 5-55
Scope of functions 5-2
Serial port on PC 5-54
Service interface 5-55
Sheet 5-41
Configuration of Functions 5-2
Configuration of the automatic reclosure function
6-207
Configuration of the Binary Inputs and Outputs
5-9
Configuring
an Indication Buffer as a Destination
5-33
and Connecting Function Modules 5-42
CFC as a Destination 5-34
Default and Control Display as a Destination
5-34
the Metered Value Window as a Destination
5-35
the System Interface as a Destination 5-34
Configuring Binary Inputs as Sources 5-28
Configuring the Default and Control Display as a
Destination
5-34
Confirmation 6-3, 6-6
Connecting an external reclosure device 6-199
Connections
to Electrical Communication Interfaces
2-20, 2-34
to Optical Communication Interfaces 2-30,
2-32
to Serial Communication Interfaces 2-20,
2-21
Connections to
Electrical Communication Interfaces
2-46
Serial Communication Interfaces 2-35,
2-48, 2-49
Connections to Terminals 2-30
Consistency check 5-43
Construction 10-13
Contact chatter suppression 5-37
Control
During Operation
7-1
Control Logic using CFC 6-323
Control Messages 7-58
Control of Device Functions 7-28
Control of Switchgear 7-46
Control of the internal automatic reclosure 6-201
Control Voltages for Binary Inputs 8-15
Controlled Zone Z1B 6-63
Copying Setting Groups 6-14
Correction of measured values for load current on
double-end fed lines
6-244
Correction of measured values on Parallel Lines
6-243
Corrective Action / Repairs 9-12
Creating User Defined Functions with CFC 5-39
Current flow monitoring 6-249
Current Inputs 10-2
Current Symmetry 6-276
Current Transformer Connection 6-9
Current Transformer Saturation 6-22
Current, Voltage, and Phase Rotation Checks
8-59
Currents 8-9
Cyclical Restoration 5-36
D
Data Connections 8-41
Data Storage for Fault Recording 6-312
Date and Time Stamping 5-58
Dead line check (DLC) 6-196
Dead line check/ reduced dead time 6-207
Dead-line or dead-bus closing 6-219
Definite Time High Set Current Stage 3I0>>
6-122
Definite Time High Set Overcurrent Stage I>>
6-163
Definite Time Overcurrent Stage 3I0> 6-122
Definite Time Overcurrent Stage I> 6-164
Definite Time Overcurrent Stages Iph>, 3I0>
6-171
Definite Time Stages 6-128
Definite Time Very High Set Current Stage
3I0>>>
6-122
Delay timers 6-255
Deleting groups 5-27
Deleting information 5-27
Description of Functions 6-227
Destination 5-19
Detached Operator Panel 10-53
Detection of Line Energization 6-292
Determination of
the Fault Location
6-242
Differential protection topology 10-29
DIGSI REMOTE 4 A-12
Dimensions 10-47
Direct Underreach Transfer Trip 6-95
Direct Voltage 10-2
Direction Determination 6-56, 6-132, 10-21
with Negative Sequence System 6-127
with the Zero Sequence System 6-126
Directional Blocking Scheme 6-146
Directional Checks with Load Current 8-60
Directional Comparison Pickup 6-99
To Next Page
Loading...
Need help?
General