Siemens siprotec 7SA6 - Page 872

Index
Index-6 7SA6 Manual
C53000-G1176-C156
Phase Segregated Fault Detection 6-296
Phase segregated initiation 6-253
Phase–Earth Loops 6-43
Phase–Phase Loops 6-42
Pick-up 6-178, 10-33
Pickup and Assignment
to the Polygons
6-59
Pick-up Mode 6-34
Pickup Scheme 6-37
Pickup Schemes 6-34
Pilot Wire Comparison 6-109
Plug-in Connectors A-11
Polarity Check 8-64
Polarity of Current Transformers 6-7
Pole discrepancy supervision 6-262
Power
Plant Connections
8-44
Power Supply 10-2
Power supply 1-4
Power Supply Voltage 8-15
Power Swing Blocking 6-76
Power Swing Supplement 1-9, 10-18
Power Swing Tripping 6-76
Power System Data 1 6-7
Presettings A-66
Primary or Secondary Values 6-6
Processing of the circuit breaker auxiliary
contacts
6-250
Processing of the Circuit Breaker Position 6-293
Processing the circuit breaker auxiliary contacts
6-192
Processor Printed Circuit Boards C-CPU-2 8-21
PROFIBUS DP 4-31
PROFIBUS FMS 4-31
Protection and Control 4-2
Protection data interface 10-29
Protection Data Interfaces and Protection Data
Topology (optional)
6-78
Protection Functions 1-5
Purpose of Setting Groups 6-14
Purpose of Signal Transmission 6-89
Q
Quantities 8-59
R
Rack Mounting and Cubicle Mounting 8-4
Rated Frequency 6-10
Rating of the Protected Plant 6-17
Read and Set Date and Time 7-28
Reading out Metered Values 7-21
Read-out of Information
Fault Records
7-26
Messages 7-2
Switching Statistics 7-13
Read-out of Measured Values 7-15
Real Time Clock and Buffer Battery 10-46
Rear Service / Modem Interface 10-6
Reassembling the Device 9-14
Reassembly of Device 8-40
Reclose Block 6-191
Reduced dead time (RDT) 6-196
Remote measured values 7-17
Remote Trip of the Circuit Breaker at the
Opposite Line End
6-160
Replacing the Buffer Battery 9-4
Replacing the Power Supply Fuse 9-13
Representation of the Time 7-29
Reset of the Trip Command 6-299
Resetting and Setting the Switching Statistics
7-14
Resetting of Metered Values and Minimum/
Maximum Values
7-24
Resistance Margin 6-61
Response to Failures 6-283
Restoring Factory Settings 6-15
Retrieval
Device configurations
5-35
Interface settings 5-56
ordering number 3-4
Retrieved messages 7-7
Return 9-16
Reverse Interlocking 6-111
Routine Checks 9-3
Routine Checks and Maintenance 9-1
RS 485 Termination 8-42
Run-Time Properties 5-39
S
Sammelmeldungen 6-286
Sampling Frequency 6-275
Saving and Erasing the Messages 7-11
Saving the Fault Records 7-27
Scope of Functions 1-9
Screw Terminal Connections 2-11, 2-29, 2-38
Selectivity before Reclosure 6-189
Sensitive Earth Fault Directional Determination
6-181
Separate Operator Control Element 10-55