Siemens SIPROTEC 7SJ61 - Page 452

Index
SIPROTEC, 7SJ61, Manual
C53000-G1140-C210-1, Release date 02.2008
452
E
Electrical Tests 313
EMC Tests for Immunity (Type Tests) 313
EMC Tests For Noise Emission (Type Test) 314
Emergency Start 111
EN100 Module
Interface Selection 47
Equilibrium Time 109
F
Fault Display
Setting Instructions 32
Fault Event Recording 362
Fault Recording 41, 362
Fiber-optic Cables 287
Final Preparation of the Device 303
Flexible Protection Functions 353
Flow Control (CTS) 278
Function Modules 356
Functional Scope 28
G
General Device Pickup 211
General tripping 212
Ground Fault 85, 86
Ground fault 91
Ground Fault Protection 50N(s), 51N(s) 346
Group Switchover of the Function Parameters 364
H
Hardware Monitoring 134
High-impedance differential protection
Sensitivity 90
Stability conditions 89
High-impedance protection 88
Hours Meter "CB open" 216
Humidity 316
I
Inrush Restraint 58
Insulation Test 313
Interlocked Switching 248
Intermittent Ground Fault Protection 156, 350
Inverse Time Overcurrent Protection 55
Inverse-Time Overcurrent Protection 51 (N) 320
L
Limits for CFC blocks 358
Limits for User-defined Functions 358
Load Jam Protection 343
Local Measured Values Monitoring 362
Long-Term Averages 361
M
Malfunction Responses of the Monitoring Functions 144
Measurement Supervision 134
Mechanical Stress Tests 315
Min / Max report 361
Minimum Inhibit Time 109
Monitoring of the Circuit Breaker Auxiliary Contacts 187
Monitoring of the Current Flow 186
Motor Restart Inhibit 66 342
Motor Starting Protection 48 341
N
Negative Sequence Protection 46-1, 46-2 334
Negative Sequence Protection 46-TOC 335
Nominal Currents 262
Non-Interlocked Switching 248
O
Offset Monitoring 136
Operating Hours Counter 363
Operating Interface 309
Operational Measured Values 355, 361
Ordering Information 370
Output Relays Binary Outputs 308
Overcurrent Protection
Single-phase 88, 333
Overcurrent Protection 50, 51, 50N, 51N
Pickup value 92
Time Delay 88
Overcurrent Protection Earth Current
Frequency 333
Overcurrent Protection single-phase
Current Elements 333
Frequency 333, 333
Overload protection 124
P
Panel Flush and Cubicle Mounting 366
Panel Surface Mounting 367
Phase rotation 209