Param‐
eter ID
Meter
version
Display
view
Parameter/data type Factory settings Data range
Fixed parameter or meter data that are not changeable
817 Advanced - Leakage status No faults Leakage status:
1: Finished successfully
2: Leakage detection running
3: Leakage detection failed (Sys‐
temStatus have fatal error)
4: Leakage detection failed
(Empty-pipe detection disabled)
5: Leakage detection failed (Coil
current off)
6: Leakage detection failed (In‐
sulation test was active during
detection)
7: Leakage detection stopped
because leakage parameter
was changed.
If none of the above-mentioned
leakage status messages is
pending, the message is "No
faults"
818 Advanced - Periods with possible
leakage
819 Advanced - Leakage periods before
alarm
30 0 to 255
820 Advanced - Reset leakage period in‐
formation
No Yes / No
Value is reset to "No" when up‐
loading device parameters to pc
after command execution
821 Advanced St1 Latest leakage period
flowrate
0
822 Advanced St1 Latest leakage period vol‐
ume
0
823 Advanced - Lowest measured leak‐
age value
1 000 000 000 The unit is updated once param‐
eter 811 change is downloaded
to device and afterwards uploa‐
ded to pc
824 Advanced - Date of lowest leakage
value
2000-01-01 T00:00 year-month-day T hours:mi‐
nutes:seconds
825 Advanced - Highest measured leak‐
age value
-1x10
9
The unit is updated once param‐
eter 811 change is downloaded
to device and afterwards uploa‐
ded to pc
826 Advanced - Date of highest leakage
value
2000-01-01 T00:00 year-month-day T hours:mi‐
nutes:seconds
830 Advanced R8 Next settling date PS3 production date and
time
year-month-day T 23:59:59
831 Advanced R9 Latest settling date PS3 production date and
time
year-month-day T 23:59:59
832 Advanced R9 Latest totalizer 1 value 0
Appendix
C.2 Parameter lists
SITRANS MAG 8000
Operating Instructions, 11/2018, A5E03071515-AE 153
To Next Page
Loading...
